This unit has 3
functions:
It has 5 different levels of heat, which range from 28°C to
42°C /
82°F to
107°F and
5 different levels of cold, which range from 4°C -
16°C /
39°F to
60°F.
You also have the option for either the hot or cold
temperatures to vibrate or not.
There is only one setting for this and it will vibrate at 9000 rpm (revolutions
per minute), that's 150 times per second which is at
Microsonic speed.
THE PRINCIPLE
1. First of
all we always begin with cleansing. Each person's face has at minimum of
20,000 pores. Whilst cleansing the skin is great but it only cleanses
the surface and is difficult to remove dirt and oil which accumulate
inside the pores causing blackheads , pimples and break-outs.
Before cleansing wet your face with water and put your Microsonic Unit
on High Heat along with vibration and proceed to move all around the
face, chin and forehead for approximately 3 minutes, this will open up
the pores so when you cleanse you will get a much deeper cleansing
result.
2. After cleansing pat
face dry and apply an appropriate serum of your choice. Place your
Microsonic Unit on Heat, you can choose any of the settings from 1 to 5
and use the vibration if you wish. Move all around the face for 2 to 3
minutes or until the Serum is absorbed.
3. Choose a Moisturizer
of your choice and apply over the face. Place your Microsonic Unit on
Heat, you can choose any of the settings from 1 to 5 and use the
vibration if you wish. Move all around the face for 2 to 3 minutes or
until the Moisturizer has absorbed.
4. Once the moisturizer
has absorbed then place your Microsonic Unit on Cold, you can choose any
of the settings from 1 to 5 and use the vibration if you wish. Move all
around the face for 2 to 3 minutes. The Cold temperature will close the
pores and lock in the serum and moisturizer giving your skin a beautiful
youthful glow with longer lasting results.
5. Remember to always
apply an appropriate sunscreen after this procedure in the mornings,
then apply make-up if you wish.
6. You can repeat steps
1 to 4 prior to retiring and apply your evening serum and moisturizer.
SAFETY & CHARGING
Plug the
Microsonic unit into a USB port either on your computer or off the main
power supply. It is compatible worldwide so no need to worry about which
voltage your country uses.
It will take
approximately 3 hours to fully charge so best to plug it in at night so
it is ready for use in the morning.
You will see the LED
light up orange and the battery indicator will flash, once charged the
light will turn to blue and the battery light will stop flashing.
Unplug, and it is ready to use. The unit will be charged for up to 10
hours of use.
For safety reasons you
cannot use the unit whilst it is plugged in and charging.
Once charged, select
the function you wish to use and it will run for 5 minutes and then
automatically turn off. If you wish to keep going, simply push the start
button again and proceed.
PERFECT
FOR
AT
HOME
FACIALS.
